Discussion Forums > Technology
Aegisub & Blu-ray & Overclocking CPU
Tatsujin:
--- Quote from: blubart on September 05, 2009, 12:57:20 AM ---
--- Quote from: Tatsujin on September 04, 2009, 11:16:23 PM ---
--- Quote ---Edit2: Shouldn't you just encode a workraw to time on? Using flac audio/whatever video bit rate you have seems a bit much for timing. Then you shouldn't run into any issues with skipping at all.
--- End quote ---
workraw?
--- End quote ---
a fast encode from the same source with a very limited bitrate. after all you don't need to watch the video in HD to time the lines right.
imo overclocking is just silly - doesn't give you any noticeable performance boost anyway.
--- End quote ---
--- Quote from: psyren on September 05, 2009, 03:03:13 AM ---
--- Quote from: psyren on September 05, 2009, 01:51:11 AM ---Learn to make workraw.
Kthnxbye.
--- End quote ---
Thread should have ended here.
--- End quote ---
With this ... make it more clear to me. Where do you get this workraw? I checked Aegisub and there is no option for Workraw.
Arveene:
You just encode the video you're working on.. at a lower bit rate.
Edit: Basically.. encode the video at a lower resolution (or if you need to typeset signs, at the normal res, but lower the bit rate a lot) and the audio at a lower bit rate. There's absolutely zero reason for it to be flac at this point. Time/TS off of that encode.
vuzedome:
--- Quote from: psyren on September 05, 2009, 03:03:13 AM ---
--- Quote from: psyren on September 05, 2009, 01:51:11 AM ---Learn to make workraw.
Kthnxbye.
--- End quote ---
Thread should have ended here.
--- End quote ---
Now we end it.
blubart:
--- Quote from: Tatsujin on September 05, 2009, 03:26:18 AM ---... make it more clear to me. Where do you get this workraw? I checked Aegisub and there is no option for Workraw.
--- End quote ---
download megui, install, open
as you have most likely not encoded the files yourself (so you don't own the source) load your raws into it, check a LQ video presetting (it doesn't really matter which one as long as it is 1pass with the same framerate as the source, the same resolution (if you want to typset signs) and a bitrate as low as 1k for 1080p) and something like 128-mp3 as the audio setting.
encode, time, ???, profit.
psyren:
Encode a small XviD/whatever version of the file for you to time to.
You don't write drafts of letters on good quality paper.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version