BakaBT > Need Help? Ask Here
New connection - want to help seeding heavily, but unable
Van.:
--- Quote from: Tolle on November 04, 2012, 05:12:09 PM ---Maximum of 25 active torrents.
--- End quote ---
25 is too little for your internet connection, it's better to double or even triple the value.
My number of active torrents on average 35-50, and it's considering that my internet speed is almost five times less than yours.
Tolle:
--- Quote from: Bob2004 on November 04, 2012, 06:10:24 PM ---"Danish Network For Research" - is that some kind of academic network? Could it be that P2P traffic is heavily restricted or blocked, hence the poor performance?
--- End quote ---
Actually, I think it's quite the opposite. The network is my universities, but living nearby, I get the same connection. The science studies use the network for research and testing, so the network should be configured to be open/available in all its forms.
However, at the moment I have "only" 8 torrents from BakaBT running - do you guys think increasing the amount of active torrents will help?
Al_Sleeper:
Yes.
Tolle:
--- Quote from: Al_Sleeper on November 04, 2012, 07:00:06 PM ---Yes.
--- End quote ---
Was that the obvious answer to anyone but me? :/
Bob2004:
--- Quote from: Tolle on November 04, 2012, 06:57:03 PM ---
--- Quote from: Bob2004 on November 04, 2012, 06:10:24 PM ---"Danish Network For Research" - is that some kind of academic network? Could it be that P2P traffic is heavily restricted or blocked, hence the poor performance?
--- End quote ---
Actually, I think it's quite the opposite. The network is my universities, but living nearby, I get the same connection. The science studies use the network for research and testing, so the network should be configured to be open/available in all its forms.
However, at the moment I have "only" 8 torrents from BakaBT running - do you guys think increasing the amount of active torrents will help?
--- End quote ---
That doesn't mean much. My university's network was the same, but it was heavily restricted - if you wanted to use a blocked port or protocol you had to submit a special application to get permission, and explaining why you needed it, before you were able to.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version